| 1. | Nonlinear mechanical analysis of belt on driving roller
驱动部输送带的非线性力学分析 |
| 2. | 2 roller : driving roller , direction - chage roller and surface - add roller
2滚简：分传动滚简改向滚简和增面滚筒。 |
| 3. | Diameter of punched driving roller is large , suiting rewinding of large and small roll
复卷驱动辊直径大，适应大小卷径的复卷。 |
| 4. | The drive motor that turns the rubberised drive roller is a high performance stepping motor
转动胶制走纸滚筒的驱动电机是高性能的步进电机。 |
| 5. | The platform is divided into three driving segments , adopting three speed - stepless motors to drive roller via wheel gear
调速输坯台分3段传动，采用3台无级变速电机通过齿轮带动辊棒。 |
| 6. | This shall erect bell cleanup scrapper in front of belt - drive roller , so that this clean up crude coal adhered onto belt
皮带驱动辊筒前安装有皮带清洁刮板，清除粘结于皮带上的原煤。 |
| 7. | S97 permanent magnet pulley can be selected as driving roller of this machine so that magnetic separation treatment can be carried out at the same time
该机的传动滚简可以选用s97系列永磁皮带轮，以便同时进行磁选处理。 |
| 8. | 5 sweeper : caput sweeper is installed at lower part of driving roller , while vacant section sweeper is installed at the end , near the direction - chage roller
5清扫器：头部清扫器安装在传动滚筒下方，空段清扫器安在尾部改向滚筒附近 |
| 9. | One end of belt - driven roller is fixed with machine body . the other end links with bolt - mode coupler at axial end of reducer . so that belt is easier replaced
皮带驱动辊筒一端固定于机体上，一端与减速机轴端插销式联轴器相连，使皮带更换更容易。 |
| 10. | Feeding and face fixing part : vfc motor , reduction drive , initiative , passivity drive roller . belt roller , face fixing , trimming and special width tape
输送整形部分：由变频控制电机、减速机、主、被动传动辊、调带辊、整形、修边及特种宽面胶带组成。 |
